Deutsch English
Startseite » Katalog » RX ANTENNEN » DXE-FCC050-H05-B Warenkorb | Kasse
Service
Bei Fragen, Anregungen oder Problemen können Sie uns jederzeit kontaktieren.

Telefonisch erreichen Sie uns
Mo. - Fr. von 09.00 - 18.00 Uhr:

Telefon: +49 4346 / 601450
Email:info@appello.de

Kategorien
 TRANSCEIVER / Receiver
 ENDSTUFEN
 RX-FILTER INRAD
 TX-FILTER
 AUTOMATISIERUNG
 STATIONSZUBEHÖR
 ANTENNEN
 ROTOREN
 RX ANTENNEN
 MASTEN+ABSPANNUNGEN
 ANTENNENZUBEHÖR
 GEBRAUCHTGERÄTE
Warenkorb
Sie haben noch keine Artikel in Ihrem Warenkorb.
Hersteller Info  
DX-Engineering
DX-Engineering
DX-Engineering Homepage
Mehr Artikel
      Erweiterte Suche »
  Hersteller:
DXE-FCC050-H05-B
DXE-FCC050-H05-B
DXE-FCC050-H05-B

DX Engineering Feedline Current Chokes, using Maxi-Core® technology, prevent unwanted RFI by eliminating feedline current and radiation in 50 ohm, coaxially fed antenna systems.
They provide excellent feedline decoupling and low loss performance from 1 to 60 MHz and are power rated for 2 kW continuous, 5 kW intermittent on antenna feedlines with an SWR below 2:1.
The new DXE-FCC050-H05-B has both SO-239 connectors isolated from the aluminum case and no stud, which replaces the original DXE-FCC050-H05-A that had only one isolated connector and a rarely used grounding stud.
This inline choke is also known as a Line Isolator, so it works very well when placed at the station end of the feedline or it may be used at the antenna end of the feedline. It behaves as a 1:1 Current Balun, even though it is connected to the antenna feedpoint with a short piece of coaxial cable.
DX Engineering Feedline Current Chokes have significantly higher common mode impedance and a larger effective core area than similar line isolators, including conventional enameled wire or bead baluns.
This results in higher power handling with lower loss, improved antenna bandwidth, and reduced RFI, and compensates for a less-than-optimal grounding system.
While the most common advice is to improve the station's RF ground, the root of the problem is in the poor isolation of the feedline from antenna currents.
In other cases, as the coax feedline travels through the near-field of the antenna, the current can be reintroduced to the feedline after the balun.

Frequency Range: 1.8-60 MHz
Ratio: 1:1
Termination Impedance (Ohms): 50
Termination Location: Top and bottom
Termination Type: UHF female, SO-239
Enclosure Type: Outdoor formed box
Enclosure Material: Aluminum
Core Type: Patented Maxi-Core®
Power Handling (CW/SSB): 2 kW/5 kW

Additional Information
Antenna Type Compatibility                             Antenna Mounting Type
Log periodic, 50 ohm, direct coax feed         Boom
Vertical, 50 ohm, direct coax feed                  Adapter bracket
Yagi, 50 ohm, direct coax feed                       Boom
Yagi, gamma matched                                    Boom




153,51 EUR incl. 19 % MWSt
129,00 EUR Exportpreis - ausserhalb Europa
 


AGB Impressum Index Kontakt 

Secure Credit Card Payments by Saferpay
IBAN International Bank Transfer Master Card PayPal

Site Verfied by SiteLock

Homepage-Sicherheit

Website by: OCTIC

Parse Time: 0.025s